Conditions for Clearing the DTC
- The condition for the DTC is no longer present.
- The EBCM clears the history DTC when a current DTC is not detected in 40 consecutive drive cycles.
NOTE:
During normal diagnostic and/or repair verification technicians may find that the ABS, Traction Control and/or Stability indicators may be ON with NO DTCs displayed by the EBCM. Do not replace the EBCM for this condition.
If the ABS, Traction Control and/or Stability indicators are ON with no DTCs set, perform the following steps:
- Remove the key from the ignition, open and close the driver's door to turn off retained accessory power (RAP), and wait 60 seconds.
- Ignition ON, if the ABS, Traction Control and/or Stability indicators are still illuminated, operate the vehicle at speeds greater than 16 km/h (10 MPH) to complete the self test. The EBCM should request all indicators to turn OFF.
- If the indicators remain ON with no DTCs set after the drive cycle, disconnect the battery for at least 60 seconds then reconnect the battery.
- Operate the vehicle at speeds greater than 40 km/h (25 MPH), the EBCM should request all indicators to turn OFF.