Circuit/System Verification
- Ignition On/Vehicle In Service Mode
- Perform the scan tool control function: Driver Window Motor Up & Down
Verify the component works as specified: M74D Window Motor - Driver = Up & Down
- If not the specified state
Test or replace the component: M74D Window Motor - Driver
- If the specified state
- If not the specified state
- Operate the component: S79D Window Switch - Driver
Verify the component works as specified: M74D Window Motor - Driver = Express Up & Express Down
- If not the specified state
Use the following procedure: Window Motor Programming - Express Function
- If the specified state
- If not the specified state
- Ignition/Vehicle & All vehicle systems Off
- Ignition On/Vehicle In Service Mode
- Operate the component: S79D Window Switch - Driver
Verify the component works as specified: M74D Window Motor - Driver = Express Up & Express Down
- If not the specified state
Test or replace the component: M74D Window Motor - Driver.
- If the specified state
- If not the specified state
- All OK.
NOTE:
It may take up to 2 min for all vehicle systems to power down before an accurate ground or low reference circuit continuity test can be performed.