Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2016 >> Spark EV >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> Hybrid/EV Control System >> Diagnostic Information and Procedures >> DTC P0C4E: Drive Motor Position Exceeded Learning Limit >> Circuit/System Verification

Circuit/System Verification

  1. Vehicle ON.
  2. Verify DTC P0A3F, P0A40, P0C52, P0C53, P0C5C, P0C5D, or P1B03 is not set.
    • If none of the DTCs are set 
  3. Verify DTC P0C4E is not set.
    • If the DTC sets 
    1. Perform each of the operations listed below one at a time until the fault is corrected.
      1. Replace the M15 Drive Motor
      2. Replace the T6 Power Inverter Module
    2. Repeat the DTC check in step 3.
    • If the DTC does not set 
  4. All OK.
scientia non olet · About Mike's Workshop Manuals