Fastener Specifications
WARNING: This page is about a different variant/trim than selected.
Single Use Threaded Fastener/Component Tightening Specifications
|
NOTE:
All fasteners/components listed in this table MUST BE DISCARDED and replaced with NEW after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Generator Bolt (L8B) | 36 N.m (27 lb ft) |
Reusable Threaded Fastener Tightening Specifications
|
NOTE:
All fasteners listed in this table can be reused after removal. |
|
|---|---|
| Application | Specification |
| Metric (English) | |
| Accessory DC Control Module Bolt | 9 N.m (80 lb in) |
| Accessory DC Control Module @ Plenum Nut | 22 N.m (16 lb ft) |
| Accessory DC Control Module @ Wheelhouse Nut | 9 N.m (80 lb in) |
| Battery Positive Cable Nut | 9 N.m (80 lb in) |
| Battery Positive Post Clamp Nut | 5 N.m (44 lb in) |
| Front End Sheet Metal Diagonal Brace Bolt | 25 N.m (18 lb ft) |
| Generator Control Module 3 Phase Cable Mounting Bolt | 9 N.m (80 lb in) |
| Generator Control Module 3 Phase Cable Terminal Bolt | 8 N.m (71 lb in) |
| Generator Control Module Mounting Nut | 22 N.m (16 lb ft) |
| Ground Terminal Fastener | 9 N.m (80 lb in) |
| Heat Shield Bolt | 9 N.m (80 lb in) |
| Hybrid Powertrain Control Module 2 Mounting Nut | 9 N.m (80 lb in) |