Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2016 >> Silverado 1500 SSV, 4WD, Part Time T/Case Control, Gas >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Hybrid/EV Control System) >> Repair Instructions >> Generator Control Module 3-Phase Cable Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Starter Generator
    GM4353331Courtesy of GENERAL MOTORS COMPANY
  1. Starter Generator - Remove - Starter Generator Replacement 
    2. Fig 2: Heat Shield Bolt
    GM4371958Courtesy of GENERAL MOTORS COMPANY
  2. Heat Shield Bolt - Remove
  3. Heat Shield - Remove
    4. Fig 3: Cover Bolt
    GM4371972Courtesy of GENERAL MOTORS COMPANY
  4. Cover Bolt - Remove
  5. Cover - Remove
    6. Fig 4: Terminal Cover Seal And Dust Cover
    GM4371975Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Clean and inspect the seal for damage.

  6. Terminal Cover Seal - Remove
  7. Dust Cover - Remove
    8. Fig 5: Generator Control Module 3 Phase Cable Terminal Bolt
    GM4371976Courtesy of GENERAL MOTORS COMPANY
  8. Generator Control Module 3 Phase Cable Terminal Bolt - Remove
    9. Fig 6: Generator Control Module 3 Phase Cable Mounting Bolt
    GM4371978Courtesy of GENERAL MOTORS COMPANY
  9. Generator Control Module 3 Phase Cable Mounting Bolt - Remove
  10. Generator Control Module 3 Phase Cable - Remove
scientia non olet · About Mike's Workshop Manuals