Circuit/System Verification
WARNING: This page is about a different variant/trim than selected.
- Verify that no other DTCs are set except for DTC P15F1.
- If any other DTCs are set
Refer to Diagnostic Trouble Code (DTC) List - Vehicle .
- If only DTC P15F1 is set
- If any other DTCs are set
- Replace the K20 Engine Control Module.
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Replace the K50 Starter/Generator Control Module.
- If the DTC does not set
- If the DTC sets
- All OK.