Blower Motor Control Module Replacement

Fig 1: Blower Motor Control Module Components

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Remove the right closeout insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side . Disconnect the blower motor resistor electrical connector.
1	Blower Motor Resistor Screw (Qty: 2) CAUTION: Refer to Fastener Caution . TIP: Remove the heat stakes that secure the blower motor resistor to the HVAC module assembly using a small chisel. Tighten 1.5 N.m (13 lb in)
2	Blower Motor Resistor Refer to Control Module References for programming and setup information.

Callout

Component Name

Preliminary Procedure

Remove the right closeout insulator. Refer to Instrument Panel Insulator Panel Replacement - Right Side .
Disconnect the blower motor resistor electrical connector.

Blower Motor Resistor Screw (Qty: 2)

CAUTION:

TIP: Remove the heat stakes that secure the blower motor resistor to the HVAC module assembly using a small chisel.
Tighten
1.5 N.m (13 lb in)

Blower Motor Resistor
Refer to Control Module References for programming and setup information.