Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2016 >> Express 2500 Base, Van Cargo Extended, 6.6L Eng VIN L >> Repair and Diagnosis >> Brakes >> Traction Control >> Antilock Brake System >> Diagnostic Information and Procedures >> DTC C0558: Calibration Data Not Programmed/Learned, Vehicle Configuration Not Programmed >> Repair Instructions

Repair Instructions

NOTE:

After a repair has been made, some DTCs require the ignition to be turned Off and then back On before the scan tool function will clear the DTC.

Complete steps as follows:

  1. Ignition Off.
  2. Install any components or connectors that have been removed or replaced during diagnosis.
  3. Perform any adjustment, programming or setup procedures that are required when a component or module is removed or replaced.
  4. Ignition On.
  5. Clear the DTCs.
  6. Turn the ignition Off for <p01> s.
  7. Perform the Circuit/System Verification and verify the result ends with an All OK. - If available

    or

    If the repair was related to a DTC, duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not set. If the DTC sets or another DTC is present, refer to:Diagnostic Trouble Code (DTC) List - Vehicle

    or

    If the repair was symptom related, duplicate the conditions under which the customer concern occurred to verify the repair. If the customer concern reoccurs or another symptom is present, refer to Symptoms - VehicleSymptoms - Vehicle

Refer to Control Module References for EBCM replacement, programming and setup

scientia non olet · About Mike's Workshop Manuals