Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2016 >> Express 2500 Base, Van Cargo Extended, 4.8L Eng VIN F >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Cellular System, Entertainment System, And Navigation System) >> Repair Instructions >> Radio Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2015 GMC Savana 3500, 2015 GMC Savana 2500, 2015 Chevrolet Express 3500, and 2015 Chevrolet Express 2500. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument cluster panel. Refer to Instrument Panel Cluster Trim Plate Bezel Replacement .
    2. Fig 1: Radio To The Support Bracket Screws
    GM665518Courtesy of GENERAL MOTORS COMPANY
  2. Remove the screws (2) that secure the radio to the support bracket (1).
  3. Remove the radio from the support bracket enough to access the connectors at rear of the radio.
  4. Disconnect the electrical/audio and antenna cable connectors from the radio.
  5. Remove the radio.
    6. Fig 2: Radio Mounting Bracket To Instrument Panel Carrier Screws
    GM639268Courtesy of GENERAL MOTORS COMPANY
  6. If removing the radio mounting bracket. Perform the following steps:
    1. Detach the clip retaining the HVAC harness to the radio mounting bracket.
    2. Remove the screws (2) retaining the radio mounting bracket (1) to the instrument panel carrier.
    3. Remove the radio mounting bracket from the vehicle.
scientia non olet · About Mike's Workshop Manuals