Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2016 >> Cruze LS, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.4L (LE2) - Repair Instructions >> Repair Instructions >> Fuel Feed Intermediate Pipe Replacement - High Pressure >> Removal Procedure

Removal Procedure

WARNING: The noise cancelling foam component MUST be replaced if it has been exposed to engine fluids. Failure to replace the noise cancelling foam component that has been exposed to engine fluids may result in an engine fire resulting in catastrophic engine damage and possible injury or death.
  1. Battery Negative Cable Disconnection and Connection » Disconnect.
  2. Engine Sight Shield Replacement » Remove
  3. Relieve the fuel system pressure.
  4. Remove the charge air cooler outlet air hose from throttle body. Refer to Charge Air Cooler Outlet Air Hose Replacement .
  5. Remove the fuel injection fuel feed pipe feed intermediate pipe - high pressure bracket bolt (3).
    Fig 1: Fuel Feed Intermediate Pipe
    GM3682444Courtesy of GENERAL MOTORS COMPANY
    NOTE: Lay a lint-free cloth under the fuel feed intermediate pipe.
  6. Loosen the 2 nuts (2, 5).
  7. Remove the fuel injection fuel feed pipe feed intermediate pipe - high pressure (4) from the fuel injection fuel rail (1) and from the fuel pump (6).
  8. Remove and DISCARD the fuel feed intermediate pipe - high pressure (4).
scientia non olet · About Mike's Workshop Manuals