Circuit/System Verification
- Engine running
- Verify DTC P0327 or P0328 is not set.
- If DTC P0327 or P0328 is set.
Refer to Circuit/System Testing.
- Go to next step: If none of the DTCs are set
- If DTC P0327 or P0328 is set.
- Verify the affected Knock Sensor is properly tightened. Refer to Fastener Specifications .
- Operate the vehicle within the conditions for running the DTC. You may also operate the vehicle within the conditions that you observed from the freeze frame/failure Records data.
- If any of the DTCs set
Refer to Circuit/System Testing.
- Go to next step: If none of the DTCs set
- If any of the DTCs set
- All OK