Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2015 >> Tahoe SSV >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Battery Control Wiring Harness Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Dual Battery) Battery Negative Cable Disconnection and Connection (Single Battery) .
    2. Fig 1: Fuse Battery Distribution Unit Engine Compartment Block Cover
    GM2964100Courtesy of GENERAL MOTORS COMPANY
  2. Remove the battery fuse block cover (2).
  3. Remove the battery fuse block fasteners (3) and remove the battery positive cable (1).
  4. Remove the generator battery control wiring harness cable (5) from the battery fuse block (4).
    5. Fig 2: Generator Battery Positive Cable Protective Boot
    GM2964099Courtesy of GENERAL MOTORS COMPANY
  5. Remove the generator battery positive cable protective boot (1).
  6. Remove the generator B + fastener (2) and remove the generator battery control wiring harness terminal (3), from the back of the generator.
    7. Fig 3: Generator Battery Control Wiring Harness Ground Fastener
    GM2964094Courtesy of GENERAL MOTORS COMPANY
  7. Remove the generator battery control wiring harness ground fastener (1) and remove the generator battery control wiring harness terminal (2), from the front engine block.
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  9. Remove the steering gear skid shield. Refer to Steering Gear Skid Shield Replacement .
    10. Fig 4: Electronic Power Steering (EPS) Connector And Generator Battery Control Wiring Harness
    GM2964097Courtesy of GENERAL MOTORS COMPANY
  10. Disconnect the electronic power steering (EPS) connector (2) from the generator battery control wiring harness (1).
    11. Fig 5: Generator Battery Control Wiring Harness Cable Fastener And Starter Stud
    GM2964095Courtesy of GENERAL MOTORS COMPANY
  11. Remove the generator battery control wiring harness cable fastener (2) from the starter stud (1) and remove the generator battery control wiring harness cable (3) from the starter.
    12. Fig 6: Generator Battery Control Wiring Harness Retainers And Generator Battery Control Wiring Harness
    GM2964093Courtesy of GENERAL MOTORS COMPANY
  12. Detach the generator battery control wiring harness retainers (1) and remove the generator battery control wiring harness (2), from the vehicle.
scientia non olet · About Mike's Workshop Manuals