Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2015 >> Spark LS, Standard Trans >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 1.2L - Diagnostic Information And Procedures >> Diagnostic Information and Procedures >> DTC P111E: Engine Coolant Temperature Sensor >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON.
  2. Verify the scan tool ECT Sensor parameter is between -39 to +120°C (-38 to +248°F) and changes with engine run time.
    • If not between -39 to +120°C (-38 to +248°F) or does not change 

      Refer to Circuit/System Testing.

    • If between -39 to +120°C (-38 to +248°F) and changes 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing.

    • If the DTC does not set 
  5. All OK.
scientia non olet · About Mike's Workshop Manuals