Installation Procedure

Install the battery positive cable (3) to the back of the generator and tighten nut (2) to 20 N.m (15 lb ft).

Fig 1: Battery Positive Cable, Nut & Generator Electrical Connector
Courtesy of GENERAL MOTORS COMPANY

CAUTION: Refer to Fastener Caution .
Install the battery positive cable (3) to the starter solenoid and tighten nut (2) to 12 N.m (9 lb ft).

Fig 2: Battery Negative Cable Stud & Starter Solenoid Nut
Courtesy of GENERAL MOTORS COMPANY
Install the battery negative cable to the starter and tighten the stud/nut (1) to 25 N.m (18 lb ft).
Install the drivetrain and front suspension frame skid plate. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement .
Install the battery negative cable nut (1) and the battery negative cable (2), to the chassis frame stud and tighten to 22 N.m (16 lb ft).

Fig 3: Battery Negative Cable & Nut
Courtesy of GENERAL MOTORS COMPANY
Install the battery positive cable (2) to the battery positive cable extension cable junction block and tighten nut (1) to 12 N.m (9 lb ft).

Fig 4: Battery Positive Cable & Nut
Courtesy of GENERAL MOTORS COMPANY
Install the battery tray. Refer to Battery Tray Replacement .
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
Install the fuse block and battery positive cable cover.