Theft Deterrent Module Replacement (Without BTM)

WARNING: This page is about a different car, the 2015 Chevrolet Impala. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Theft Deterrent Module (Without BTM)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedure Steering Column Lower Trim Cover Replacement (N38) and Steering Column Lower Trim Cover Replacement (N37)
1	Theft Deterrent Module Fastener [2x] CAUTION: Refer to Fastener Caution .
2	Theft Deterrent Module Procedure Disconnect the electrical connector. Release the retaining tabs and remove the theft deterrent module from the ignition and start switch housing. Perform the necessary programming and setup procedure: Control Module References

Callout

Component Name

Preliminary Procedure
Steering Column Lower Trim Cover Replacement (N38) and Steering Column Lower Trim Cover Replacement (N37)

Theft Deterrent Module Fastener [2x]

CAUTION: Refer to Fastener Caution .

Theft Deterrent Module

Procedure

Disconnect the electrical connector.
Release the retaining tabs and remove the theft deterrent module from the ignition and start switch housing.
Perform the necessary programming and setup procedure: Control Module References