Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2015 >> Cruze LS, 1.8L Eng VIN H, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

  1. Install the fuel tank pressure sensor (2) to the evaporative emission canister (3)
    Fig 1: Fuel Tank Pressure Sensor Electrical Connector And Fuel Tank Pressure Sensor
    GM3398186Courtesy of GENERAL MOTORS COMPANY
  2. Connect the fuel tank pressure sensor electrical connector (1) to the fuel tank pressure sensor (2).
  3. Raise the fuel tank to its original position.
  4. Install the 2 fuel tank straps (1).
    Fig 2: Fuel Tank Straps
    GM2028244Courtesy of GENERAL MOTORS COMPANY
  5. Install the 2 fuel tank strap bolts (2) and tighten to 22 N.m (16 lb ft).
    CAUTION: Refer to Fastener Caution .
  6. Remove the suitable adjustable jack.
  7. Install the fuel tank filler hose (3) to the fuel tank filler pipe (1).
    Fig 3: Fuel Tank Filler Pipe
    GM2028238Courtesy of GENERAL MOTORS COMPANY
  8. Install the clamp (2).
  9. Lower the vehicle.
  10. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals