Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2015 >> Cruze LS, 1.8L Eng VIN H, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.8L (LUW, LWE) - Repair Instructions >> Repair Instructions >> Fuel Injector Replacement >> Installation Procedure

Installation Procedure

  1. Install the fuel injectors.
    Fig 1: View Of Injectors Retaining Clamps
    GM1940561Courtesy of GENERAL MOTORS COMPANY
  2. Install the fuel injector retainer (1).
    NOTE: Install NEW fuel injector seals, coat the multiport fuel injector seals with silicone grease.
  3. Install the 4 NEW fuel injector seals (6).
    Fig 2: Multiport Fuel Injection Fuel Rail And Bolts
    GM2028209Courtesy of GENERAL MOTORS COMPANY
    NOTE: Coat the fuel injector seals with silicone grease.
  4. Install the multiport fuel injection fuel rail (4) and the fuel injectors (5) to the intake manifold (7).
  5. Install the 2 multiport fuel injection fuel rail bolts (3) and tighten to 8 N.m (71 lb in).
    CAUTION: Refer to Fastener Caution .
  6. Install the evaporative emission canister purge solenoid valve bracket (1) to the intake manifold (7).
  7. Install the 2 evaporative emission canister purge solenoid valve bracket bolts (2) and tighten to 8 N.m (71 lb in).
  8. Remove the cap from the fuel feed pipe (1).
    Fig 3: View Of Fuel Return Line
    GM1944873Courtesy of GENERAL MOTORS COMPANY
  9. Connect the quick-release fitting of fuel feed pipe (1).
  10. Connect the wiring harness to the:
    1. Evaporative emission purge valve
    2. Fuel injectors
    3. Manifold absolute pressure sensor
  11. Install the positive crankcase ventilation tube. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replacement .
  12. Connect the negative cable from the battery. Refer to Battery Negative Cable Disconnection and Connection .
  13. Close the hood.
scientia non olet · About Mike's Workshop Manuals