Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2015 >> Cruze Diesel >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.0L (LUZ) Diesel - Repair Instructions >> Repair Instructions >> Exhaust Gas Recirculation Valve Replacement >> Removal Procedure

Removal Procedure

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
  3. Drain the cooling system. Refer to Cooling System Draining and Filling (GE-47716 Fill)Cooling System Draining and Filling (Static Fill) .
  4. Unclip the 3 wiring harness clips (1) from the exhaust gas recirculation pipe bracket (2).
    Fig 1: Wiring Harness Clips And Exhaust Gas Recirculation Pipe Bracket
    GM3416093Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the exhaust gas recirculation valve wiring harness plug.
  6. Remove the 3 exhaust pressure sensor pipe bolts (3, 6).
    Fig 2: Clamps
    GM2966396Courtesy of GENERAL MOTORS COMPANY
  7. Push the exhaust pressure sensor pipe (5) slightly upwards, to reach the upper exhaust gas recirculation valve bolt.
  8. Remove the 2 exhaust gas recirculation valve bolts (4).
    Fig 3: Exhaust Gas Recirculation Valve And Bolts
    GM2191217Courtesy of GENERAL MOTORS COMPANY
    NOTE: Place a basin underneath.
  9. Remove the exhaust gas recirculation valve (3).
  10. Remove the exhaust gas recirculation valve flat washer (5).
  11. Remove the 4 closing plate bolts (2).
  12. Remove the closing plate (1).
  13. Clean the surface with soft cloth.
scientia non olet · About Mike's Workshop Manuals