Generator Bracket Replacement (LS7, LSA)

Fig 1: Generator, Stud & Fasteners (LS7, LSA)

Courtesy of GENERAL MOTORS COMPANY

Callout	Component Name
Preliminary Procedures Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection . Remove the generator. Refer to Generator Replacement (LS7, LSA) .
1	Generator Stud CAUTION: Refer to Fastener Caution . Tighten 20 N.m (15 lb ft)
2	Generator Fastener (Qty: 2) Tighten 50 N.m (37 lb ft)
3	Generator Procedure Transfer the drive belt idler pulley, if necessary. Refer to Drive Belt Idler Pulley Replacement (LSA, LS7 Upper)Drive Belt Idler Pulley Replacement (LSA, LS7 Lower) . Install the generator stud (1) with the generator installation.