Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Trax LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Battery Negative Cable And Current Sensor
    GM2027819Courtesy of GENERAL MOTORS COMPANY
  1. Install the current sensor (2) to the battery negative cable (1).
    2. Fig 2: Wiring Harness Current Sensor Connector
    GM2773965Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  2. Install the body harness ground cable (2) to the battery negative cable (6). Tighten the fastener (1) to 9 N.m (80 lb in).
  3. Connect the wiring harness current sensor connector (3).
    4. Fig 3: Battery Ground Cable And Fastener
    GM2773967Courtesy of GENERAL MOTORS COMPANY
  4. Install the battery negative cable (2) to the chassis frame stud and tighten the fastener (1) to 9 N.m (80 lb in).
  5. Install the battery tray. Refer to Battery Tray Replacement .
  6. Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About Mike's Workshop Manuals