Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Trax LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Wiper System And Washer System) >> Repair Instructions >> Windshield Wiper Motor Replacement

Windshield Wiper Motor Replacement

WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Windshield Wiper Motor
GM2844478Courtesy of GENERAL MOTORS COMPANY
Windshield Wiper Motor Replacement

Callout Component Name
Preliminary Procedure 
Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement (Buick) 
Remove the windshield wiper transmission. Refer to Windshield Wiper Transmission Replacement 
1 Windshield Wiper Motor Bracket Screw (Qty: 2)
CAUTION:

Refer to Fastener Caution .
2 Windshield Wiper Motor

Procedure

  1. Use a wiper linkage separator or similar tool, separate the transmission drive link from the wiper motor crank arm ball stud.
  2. Remove the windshield wiper motor from the wiper transmission.
  3. Position the new windshield wiper motor to the transmission.
  4. Align the transmission links to the wiper motor crank arm.
  5. Use a wiper linkage installer or similar tool, to install the transmission drive link onto the wiper motor crank arm ball stud.
    NOTE:

    Apply a small amount of grease to the inner cup on the transmission link to aid in installation.


Special Tools 
J-39232  Wiper Linkage Separator
J-39529  Wiper Linkage Installer
For equivalent regional tools. Refer to Special Tools 
scientia non olet · About Mike's Workshop Manuals