Windshield Washer Solvent Container Replacement
WARNING: This page is about a different car, the 2013 Chevrolet Trax and 2013 Buick Encore. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS COMPANY Windshield Washer Solvent Container Replacement
| Callout |
Component Name |
|
Preliminary Procedure
- Remove the windshield washer solvent container filler tube. Refer to Windshield Washer Solvent Container Filler Tube Replacement
- Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement (Buick)
.
- Disconnect the windshield washer pump hose.
|
| 1 |
Windshield Washer Solvent Container Nut (Qty: 3)
Tighten
5 (44 lb in) |
| 2 |
Windshield Washer Solvent Container
- Remove washer solvent container from the front compartment panel assembly and lower the washer container from the wheelhouse compartment.
- Drain the windshield washer solvent into a suitable clean container.
- Transfer the component parts as needed.
- Install a new grommet prior to installing the windshield washer pump into the washer solvent container.
- Fill the windshield washer solvent container after installation.
|