Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

  1. Remove the engine mount strut bracket. Refer to Engine Mount Strut Bracket Replacement - Right Side .
    Fig 1: Identifying Remote Power Steering Fluid Reservoir, Bracket & Bolts
    GM1856014Courtesy of GENERAL MOTORS COMPANY
  2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement .
  3. Remove the power steering fluid reservoir bracket bolts (1).
  4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.
  5. Disconnect the engine wiring harness electrical connector (8) from the bank 2 intake camshaft position (CMP) sensor (7).
    Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  6. Remove the CMP sensor bolt and sensor (3).
    Fig 3: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About Mike's Workshop Manuals