Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 1 (Right Side) Intake >> Installation Procedure

Installation Procedure

  1. Install the CMP sensor (2) and bolt. Tighten the bolt to 10 N.m (89 lb in).
    Fig 1: View Of CMP Sensor Bolt & Sensor
    GM1860459Courtesy of GENERAL MOTORS COMPANY
    CAUTION: Refer to Fastener Caution .
  2. Connect the engine wiring harness electrical connector (1) to the bank 1 intake CMP sensor (2).
    Fig 2: Identifying Intake & Exhaust Camshaft Position (CMP) Sensors
    GM1860428Courtesy of GENERAL MOTORS COMPANY
scientia non olet · About Mike's Workshop Manuals