Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Traverse LS, 4D Utility >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Keyless Entry System And Remote Functions >> Diagnostic Information and Procedures >> Garage Door Opener Malfunction >> Circuit/System Testing

Circuit/System Testing

  1. Ignition OFF, disconnect the harness connector at the GDO.
  2. Ignition OFF, test for less than 10 Ω between the ground circuit terminal 3 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify a test lamp illuminates between the B+ circuit terminal 1 and ground.
    • If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance.
  4. Ignition ON, hold the two outer buttons on the GDO for 30 seconds. After 20 seconds, the LEDs will flash indicating that all learned transmitter values have been cleared. After an additional 10 seconds, the LEDs will flash again indicating it has entered the diagnostic mode. Place the J 41540  universal home remote tester near the GDO and individually press each button of the GDO. The tester should indicate when each button is pressed.
    NOTE: This step will clear any learned transmitters from the GDO. This will require reprogramming by the customer to reestablish GDO functionality.
    • If one or more of the buttons does not respond when each button is pressed, replace the GDO.
  5. Instruct the customer to program the GDO. Refer to the vehicle owner's manual. A possible rolling code or incompatibility with the GDO receiver will prevent programming.
scientia non olet · About Mike's Workshop Manuals