Circuit/System Verification
- Ignition ON, observe the DTC information with a scan tool. Verify that DTC P0602 does not fail this ignition cycle.
- If DTC P0602 failed this ignition, reprogram the K71 TCM. Refer to Control Module References . If DTC P0602 resets, replace the K71 TCM.
- Observe the DTC information with a scan tool. Verify that DTCs P0601, P0604, and P062F do not set this ignition cycle.
- If any of the DTCs P0601, P0604, or P062F are set this ignition cycle, replace the K71 TCM.