Circuit/System Verification
- Verify the cooling system is filled to the correct coolant level. Refer to Cooling System Leak Testing
and Cooling System Draining and Filling
.
- If the coolant level is not correct
Repair as necessary
- If the coolant level is correct
- If the coolant level is not correct
- Verify the DTC P00B7, P0116, P0117, P0118, P0597, P0598 or P0599 is not set.
- If a DTC is set
- If a DTC is not set
- Engine running for 15 min with the A/C OFF, increase the engine speed to 3, 000 RPM.
- Verify the scan tool ECT Sensor parameter is greater than 79°C (174°F) when commanding the Engine Coolant Thermostat Heater to 0%.
- If less than 79°C (174°F)
Replace the E41 Engine Coolant Thermostat Heater.
- If greater than 79°C (174°F)
- If less than 79°C (174°F)
- Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
- Verify the DTC does not set.
- If the DTC sets
Refer to Step 1.
- If the DTC does not set
- If the DTC sets
- All OK.