Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Spark LS, Standard Trans >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 1.2L - Repair Instructions >> Repair Instructions >> Camshaft Position Actuator Solenoid Valve Replacement (LFM) >> Installation Procedure

Installation Procedure

    Fig 1: Camshaft Position Actuator Solenoid Valve Bolts
    GM2810160Courtesy of GENERAL MOTORS COMPANY
    NOTE:

    Lubricate the NEW camshaft position actuator solenoid valve seals with NEW engine oil.

  1. Install NEW 2 camshaft position actuator solenoid valve seal (3).
  2. Install the camshaft position actuator solenoid valves (2).
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the camshaft position actuator solenoid valve bolts (1) and tighten to 10 (53 lb in).
  4. Connect the camshaft position actuator solenoid valve electrical connector.
    5. Fig 2: Evaporative Emission Canister Purge Solenoid Valve Hose
    GM3416010Courtesy of GENERAL MOTORS COMPANY
  5. Connect the power brake booster vacuum hose (2) from the upper intake manifold. Refer to Power Brake Booster Vacuum Hose Replacement .
  6. Connect the evaporative emission canister purge solenoid valve hose (1) from the upper intake manifold. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement (LL0) , Evaporative Emission Canister Purge Solenoid Valve Replacement (LFM) .
  7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  8. Close the hood.
scientia non olet · About Mike's Workshop Manuals