Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> SS >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls And Fuel - 6.2L (LS3) - DTC P0016 To DTC P0430 >> Diagnostic Information and Procedures >> DTC P0116 >> Circuit/System Verification

Circuit/System Verification

  1. Ignition ON.
  2. Verify the scan tool ECT Sensor parameter is warmer than -40° C (-40° F) and colder than 150° C 302° F) and changes with engine run time.
    • If colder than -39° C (-38° F) or warmer than 149° C 300°F) or does not change 

      Refer to Circuit/System Testing (below).

    • If warmer than -40° C (-40°F) and colder than 150° C 302°F) and changes 
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
  4. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing (below).

    • If the DTC does not set 
  5. All OK.
scientia non olet · About Mike's Workshop Manuals