Component Testing

Relay Test

1. Ignition OFF, disconnect the KR95A Liftgate Unlatch Relay.
2. Test for 60-200 Ω between terminals 86 and 85.
   • If less than 60 Ω or greater than 200 Ω 

     Replace the KR95A Liftgate Unlatch Relay.

   • If between 60-200 Ω 
3. Test for infinite resistance between the terminals listed below:
   • 87 and 30
   • 87 and 86
   • 87 and 85
   • 86 and 30
   • If less than infinite resistance 

     Replace the KR95A Liftgate Unlatch Relay.

   • If infinite resistance 
4. Install a 3 A fused jumper wire between relay terminal 86 and 12 V. Install a jumper wire between relay terminal 85 and ground.
5. Test for less than 2 Ω between terminals 87 and 30.
   • If 2 Ω or greater 

     Replace the KR95A Liftgate Unlatch Relay.

   • If less than 2 Ω 
6. All OK