Component Testing

Liftgate Release Switch

1. Ignition OFF, disconnect the harness connector at the S46 liftgate handle switch.
2. Test for infinite resistance between the signal terminal 1 and the ground terminal 2 with the switch in the open position.
   • If less than infinite resistance 

     Replace the S46 liftgate handle switch.

   • If infinite resistance 
3. Test for less than 3 Ω between the signal terminal 1 and the ground terminal 2 with the switch in the closed position.
   • If 3 Ω or greater 

     Replace the S46 liftgate handle switch.

   • If less than 3 Ω 
4. All OK