Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Express 2500 Base, Van Cargo Extended, 6.6L Eng VIN L >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 6.6L (LGH) - Repair Instructions >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

    Fig 1: View Of Crankshaft Position Sensor Electrical Connector
    GM1335470Courtesy of GENERAL MOTORS COMPANY
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Disconnect the crankshaft position (CKP) sensor electrical connector.
  4. Fig 2: View Of CKP Sensor & Bolt
    GM1336119Courtesy of GENERAL MOTORS COMPANY

    Remove the CKP sensor bolt.
  5. Remove the CKP sensor.
  6. If necessary, remove the CKP sensor spacer bolts.
  7. If necessary, remove the CKP sensor spacer.
scientia non olet · About Mike's Workshop Manuals