Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Express 1500 Base, 4.3L Eng VIN X, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls & Fuel - 4.3 (LU3) - Repair Instructions >> Repair Instructions >> Throttle Body Assembly Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Throttle Body, Gasket & Bolts
    GM1937515Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW throttle body gasket (3) into the upper intake manifold.
  2. Place the throttle body (2) onto the upper intake manifold.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the throttle body bolts (1) and tighten to 10 N.m (89 lb in).
    4. Fig 2: Identifying Manifold Absolute Pressure Sensor Components
    GM1934568Courtesy of GENERAL MOTORS COMPANY
  4. Connect the engine wiring harness electrical connector (3) to the throttle actuator (2).
  5. Install the air cleaner outlet resonator. Refer to Air Cleaner Outlet Resonator Replacement .
  6. Perform the throttle learn procedure. Refer to Q38 Throttle Body: Throttle/Idle Learn .
scientia non olet · About Mike's Workshop Manuals