Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Express 1500 Base, 4.3L Eng VIN X, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls & Fuel - 4.3 (LU3) - Repair Instructions >> Repair Instructions >> Knock Sensor 1 Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View Of Knock Sensor & Bolt
    GM1877015Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Position the knock sensor to the engine block and install the bolt. Tighten to 25 N.m (18 lb ft)
    2. Fig 2: Identifying Knock Sensor Wiring Harness Electrical Connector
    GM1950124Courtesy of GENERAL MOTORS COMPANY
  2. Connect the engine wiring harness electrical connector (1) to the knock sensor.
  3. Position the knock sensor sleeve up and over the knock sensor, if equipped.
  4. Lower the vehicle.
scientia non olet · About Mike's Workshop Manuals