Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Cruze Diesel >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls And Fuel - 2.0L (LUZ) Diesel - Repair Instructions >> Repair Instructions >> Fuel Feed Pipe Replacement >> Removal Procedure

Removal Procedure

WARNING:

Refer to Gasoline/Gasoline Vapors Warning .

WARNING:

Always wear safety goggles when working with fuel in order to protect the eyes from fuel splash.

  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine sight shield. Refer to Engine Sight Shield Replacement .
    3. Fig 1: Fuel Feed Pipe Clamp And Fuel Injection Fuel Pump
    GM2190463Courtesy of GENERAL MOTORS COMPANY
  3. Remove the fuel feed pipe clamp (2) by using GE-47622  hose clamp pliers.
  4. Remove the fuel feed pipe (3) from the fuel injection fuel pump (1).
  5. Close all connections with EN-6015  plugs.
  6. Close the connection from fuel injection pump by using EN-6368  plugs.
  7. Open the upper bulk head retainer (4) and unclip the fuel feed pipe (3).
  8. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
    9. Fig 2: Front Exhaust Hanger Bracket And Bolt
    GM2538049Courtesy of GENERAL MOTORS COMPANY
  9. Remove and DISCARD the exhaust front hanger bracket bolt (3).
  10. Remove and DISCARD the frame reinforcement bolt (2).
  11. Loosen the drivetrain and front suspension frame bolt (1).
    12. Fig 3: Right Frame Reinforcement
    GM2538051Courtesy of GENERAL MOTORS COMPANY
  12. Rotate the right frame reinforcement (1) to a position shown to get access to the fuel pipes.
    13. Fig 4: Fuel Feed Pipe And Clips
    GM2191622Courtesy of GENERAL MOTORS COMPANY
  13. Open the 4 fuel pipe clips (2).
  14. Remove the lower bulk head clip.
    15. Fig 5: Disconnectting Fuel Feed Pipe And Fuel Feed Pipe Connector
    GM2028100Courtesy of GENERAL MOTORS COMPANY
  15. Disconnect the fuel feed pipe (3) from the fuel feed pipe connector (1). Refer to Plastic Collar Quick Connect Fitting Service .
  16. Close all connections with EN-6015  plugs.
  17. Remove the fuel feed pipe (3).
scientia non olet · About Mike's Workshop Manuals