Component Testing
- Ignition OFF, disconnect the harness connector at the S75 Traction Control Switch.
- Test for infinite resistance between the signal circuit terminal 7 and the ground circuit terminal 2 with the switch in the open position.
- If less than infinite resistance
Replace the S75 Traction Control Switch.
- If less than infinite resistance
- Test for less than 2 between the signal circuit terminal 7 and the ground circuit terminal 2 with the switch in the closed position.
- If 2 or greater
Replace the S75 Traction Control Switch.
- If less than 2
- If 2 or greater
- All OK.