Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2014 >> Camaro LS, Automatic Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Controls And Fuel - 3.6L - Repair Instructions) >> Repair Instructions >> Accelerator Pedal Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2011 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the closeout/insulator panel from under the dashboard on the drivers side.
    2. Fig 1: Locating APP Sensor And Fasteners
    GM1407620Courtesy of GENERAL MOTORS CORP.
    CAUTION: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
  2. Disconnect the accelerator pedal position (APP) sensor electrical connector from the accelerator pedal module.
  3. Remove the nuts from the APP sensor and remove the APP sensor from the front of dash.
scientia non olet · About Mike's Workshop Manuals