Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2013 >> Volt >> Repair and Diagnosis >> Hybrid/Electric Powertrain >> Electric Converters and Controllers >> Hybrid/EV Control System >> Diagnostic Information and Procedures >> DTC P0BFD or P0BFE >> Circuit/System Verification

Circuit/System Verification

  1. Vehicle ON.
  2. Verify DTC P0BFD or P0BFE is not set.
    • If any of the DTCs are set 
    1. Clear the DTC, vehicle OFF for 2 minutes to allow all control modules to shut down.
    2. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
    3. Verify the DTC does not set.
      • If the DTC sets, continue to Circuit/System Testing.
      • If the DTC does not set.
    4. All OK
    • If none of the DTCs are set 
  3. All OK
scientia non olet · About Mike's Workshop Manuals