Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2013 >> Traverse LS, AWD >> Repair and Diagnosis >> Engine Performance >> Engine Control Systems >> Engine Controls/Fuel - 3.6L (LLT) - Repair Instructions >> Repair Instructions >> Camshaft Position Sensor Replacement - Bank 2 (Left Side) Intake >> Removal Procedure

Removal Procedure

    Fig 1: Remote Power Steering Fluid Reservoir, Bracket
    GM1856014Courtesy of GENERAL MOTORS COMPANY
  1. Remove the engine mount strut bracket. Refer to ENGINE MOUNT STRUT BRACKET REPLACEMENT - RIGHT SIDE .
  2. Remove the radiator inlet hose from the water outlet. Refer to Radiator Inlet Hose Replacement .
  3. Remove the power steering fluid reservoir bracket bolts (1).
  4. Remove and reposition the power steering fluid reservoir bracket (2) out of the way.
    5. Fig 2: Intake And Exhaust Camshaft Position (CMP) Sensors
    GM1860429Courtesy of GENERAL MOTORS COMPANY
  5. Disconnect the engine wiring harness electrical connector (8) from the bank 2 intake camshaft position (CMP) sensor (7).
    6. Fig 3: CMP Sensor Bolt And Sensor
    GM1860459Courtesy of GENERAL MOTORS COMPANY
  6. Remove the CMP sensor bolt and sensor (3).
scientia non olet · About Mike's Workshop Manuals