Installation Procedure
WARNING: This page is about a different car, the 2012 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
- Install the exhaust system.
- Install the NEW exhaust front pipe gasket (4).
- Install the 3 NEW catalytic converter nuts (3) to the exhaust front pipe (2) and tighten to 22 N.m (16 lb ft).
- Install the heated oxygen sensor (1) and tighten to 42 N.m (31 lb ft).
- Install the 2 exhaust pipe front hanger bracket insulators (1).
- Install the exhaust pipe front hanger bracket (2).
- Install the 2 exhaust pipe front hanger bracket insulator nuts (3) and tighten to 17 N.m (13 lb ft).
- Install the 4 exhaust pipe front hanger bracket bolts (4, 5) and tighten to 22 N.m (16 lb ft).
- Install the 2 exhaust pipe front hanger bolts (5) - M10 and tighten to 60 N.m (44 lb ft).
- Install the exhaust rear muffler. Refer to Exhaust Rear Muffler Replacement .
NOTE:
A second technician is required.
CAUTION:
Refer to Fastener Caution .
CAUTION:
Refer to Torque-to-Yield Fastener Caution .