Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Repair Instructions >> Repair Instructions >> Ignition and Start Switch Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of Key Alarm Connector, Tapping Screws, Ignition Lock Cylinder Case and Ignition Switch Assembly
    GM324871Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install the ignition switch assembly (2) and secure by using 2 tapping screws (3).

    Tighten 

    Tighten the screws to 7 N.m (62 lb in).

  2. Install the ignition switch assembly connector (1) onto the ignition lock cylinder case (4).
    3. Fig 2: Theft Deterrent Control Module Connector
    GM420192Courtesy of GENERAL MOTORS COMPANY
  3. Connect the theft deterrent control module connector.
  4. Connect the fused jumper assembly connector.
    5. Fig 3: Locating Theft Deterrent Module & Ignition Lock Cylinder Case Assembly
    GM324869Courtesy of GENERAL MOTORS COMPANY
  5. Install the theft deterrent control module (2) onto the ignition lock cylinder case (1).
  6. Install the ignition lock cylinder. Refer to Ignition Lock Cylinder Replacement .
  7. Install the upper and lower trim covers. Refer to Steering Column Trim Cover Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
scientia non olet · About Mike's Workshop Manuals