Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> Body & Frame >> Ignition Switch/Steering Lock >> Wiring Systems And Power Management - Repair Instructions >> Repair Instructions >> Accessory Wiring Junction Block Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Electrical Center Bracket & Fasteners
    GM1592792Courtesy of GENERAL MOTORS COMPANY
    CAUTION:

    Refer to Fastener Caution .

  1. Install fasteners (1) securing the electrical center (2) to vehicle.

    Tighten 

    Tighten the fasteners to 10 N.m (86 lb in).

    2. Fig 2: Identifying Electrical Center Board & Fasteners
    GM1592791Courtesy of GENERAL MOTORS COMPANY
  2. Install the fasteners (1) securing the electrical center board (2).

    Tighten 

    Tighten the fasteners to 7 N.m (62 lb in).

  3. Connect the positive battery cable. Refer to Battery Positive and Negative Cable Replacement .
    4. Fig 3: Identifying Electrical Center Cover
    GM1592786Courtesy of GENERAL MOTORS COMPANY
  4. Install the electrical center cover (1).
scientia non olet · About Mike's Workshop Manuals