Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2013 >> Impala LS >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Cellular System, Entertainment System, And Navigation System >> Repair Instructions >> Digital Radio Antenna Cable Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Routing Antenna Cable
    GM859172Courtesy of GENERAL MOTORS COMPANY
  1. Install the antenna cable retainers to the receiver bracket.
  2. Connect the antenna cable to the digital radio receiver.
  3. Attach the wire or string used in the removal procedure to the cable being installed.
  4. Carefully pull the antenna cable through the rear shelf into the passenger compartment.
  5. Install the right rear compartment trim panel.
  6. Remove the wire or string from the antenna cable.
  7. Route the antenna cable between the dome lamp harness and the upper quarter panel.
  8. Install the antenna cable to the dome lamp harness clips.
    9. Fig 2: Antenna Cable, Retainer & Rear Header
    GM859171Courtesy of GENERAL MOTORS COMPANY
  9. Install the antenna cable retainer (3) to the rear header (2).
  10. Connect the antenna cable to the antenna base cable connector.
  11. Install the antenna cable mastic patch/tape at the roof.
  12. Install the rear of the headliner. Refer to Headlining Trim Panel Replacement .
  13. Install the right rear upper quarter trim panel. Refer to Quarter Upper Trim Panel Replacement .
scientia non olet · About Mike's Workshop Manuals