Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Volt >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls/Fuel - 1.4L (LUU) - DTC P0010 To DTC P0499 >> Diagnostic Information and Procedures >> DTC P0106 >> Circuit/System Testing

Circuit/System Testing

  1. Verify the integrity of the air induction system by inspecting for the following conditions:
    • Any damaged components
    • Loose or improper installation
    • Improperly routed vacuum hoses
    • Any vacuum leak
    • Any type of restriction
    • MAP sensor seal that is missing or damaged
  2. Verify that restrictions do not exist in the exhaust system. Refer to Restricted Exhaust .
  3. Vehicle OFF, disconnect the harness connector at the B74 MAP sensor.
  4. Vehicle OFF, all systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 5 Ω between the low reference circuit terminal 2 and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  5. Vehicle in Service Mode, test for 4.8-5.2 V between the 5 V reference circuit terminal 1 and ground.
    • If less than the specified range, test the 5 V reference circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  6. Verify the scan tool MAP Sensor parameter is less than 0.5 V.
    • If greater than the specified range, test the signal circuit terminal 3 for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  7. Install a 3 A fused jumper wire between the signal circuit terminal 3 and the 5 V reference circuit terminal 1. Verify the scan tool MAP Sensor parameter is greater than 4.7 V.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  8. If all circuits test normal, test or replace the MAP sensor.
scientia non olet · About Mike's Workshop Manuals