Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 405 (Power Door Lock System And Release Systems) >> Diagnostic Information and Procedures >> DTC B153E: Liftgate Angle Sensor Malfunction >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2016 GMC Acadia, 2016 Chevrolet Traverse, and 2016 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X3 harness connector at the liftgate control module.
  2. Test for less than 1 Ω between the low reference terminal 11 at the liftgate control module and ground.
    • If greater than the specified range, replace the liftgate control module.
  3. Ignition ON, test for 4.8 - 5.2 V between the 5 V reference terminal 8 at the liftgate control module and ground.
    • If not within the specified range, replace the liftgate control module
  4. Test for 4.8 - 5.2 V between the sensor 1 signal terminal 9 and low reference terminal 11 at the liftgate control module.
    • If not within the specified range, replace the liftgate control module.
  5. Test for 4.8 - 5.2 V between the sensor 2 signal terminal 10 and low reference terminal 11 at the liftgate control module.
    • If not within the specified range, replace the liftgate control module.
  6. If all circuits test normal, test or replace the liftgate actuator assembly.
scientia non olet · About Mike's Workshop Manuals