Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Engine Exhaust System) >> Repair Instructions >> Catalytic Converter Replacement - Right Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Catalytic Converter Exhaust Manifold Nuts
    GM1861341Courtesy of GENERAL MOTORS COMPANY
  1. Install a NEW catalytic converter to exhaust manifold seal (1) onto the catalytic converter.
  2. Install the catalytic converter to the exhaust manifold.
    3. CAUTION:

    Refer to Fastener Caution .

  3. Install the catalytic converter to exhaust manifold nuts (2).

    Tighten 

    Tighten the nuts to 50 N.m (37 lb ft).

  4. If equipped with all wheel drive (AWD), install the transfer case. Refer to Transfer Case Assembly Replacement .
  5. Install the exhaust flexible pipe. Refer to Exhaust Flexible Pipe Replacement .
scientia non olet · About Mike's Workshop Manuals