Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 162 (Battery, Charging System And Starting System) >> Repair Instructions >> Battery Negative Cable Disconnection and Connection >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2013 GMC Acadia, 2013 Chevrolet Traverse, and 2013 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:

Refer to Battery Disconnect Warning .

  1. Remove the floor matt from between the front and middle row passenger seat, if equipped.
  2. Place the front passenger seat in the full forward position.
  3. Remove the rear seat front trim covers.
    4. Fig 1: Battery Cover Screw And Cover
    GM1860911Courtesy of GENERAL MOTORS COMPANY
  4. Record all of the customers radio station presets.
  5. Turn OFF all the lamps and accessories.
  6. Ensure the ignition switch is in the OFF position and the key is removed.
  7. From inside the vehicle, remove the battery cover screw and cover.
    8. Fig 2: Negative Battery Cable Terminal And Nut
    GM1860912Courtesy of GENERAL MOTORS COMPANY
  8. Loosen the negative battery cable clamp nut (1) at the battery negative post (2).
  9. Remove the negative battery cable clamp from the battery negative post (2) and set aside.
scientia non olet · About Mike's Workshop Manuals