Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Chevrolet >> 2012 >> Traverse LS, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Replacement (LF1) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac SRX. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Starter Motor & Bolts
    GM2201749Courtesy of GENERAL MOTORS CORP.
  1. Install the starter motor (2).
    2. CAUTION: Refer to Fastener Caution .
  2. Install the starter motor mounting bolts. Tighten to 58 N.m (43 lb ft).
    3. Fig 2: View Of Starter & Solenoid & Cables
    GM2196014Courtesy of GENERAL MOTORS CORP.
  3. Install the battery positive cable and engine harness connector to the starter. Tighten the battery positive cable nut (1) to 15 N.m (9 lb ft).
  4. Install the engine harness connector to the starter solenoid.
    5. Fig 3: View Of Starter & Heat Shield
    GM2196015Courtesy of GENERAL MOTORS CORP.
  5. Install the starter heat shield (2) and tighten the bolt (1) to 7 N.m (62 lb in).
  6. Connect the knock sensor connector.
  7. Install the left catalytic converter to the cylinder head.
scientia non olet · About Mike's Workshop Manuals