Removal Procedure

Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection and Connection (without Start/Stop System) .

Fig 1: Battery Fuse Box Cover

GM2577153

Courtesy of GENERAL MOTORS COMPANY

Unlock the retaining tab (1) on the battery fuse box cover.
Use a suitable screw driver (2) to unlock the clip (4) through the window (3).

Fig 2: Fuse Box Cover, Battery Cable And Nut

GM2027594

Courtesy of GENERAL MOTORS COMPANY

NOTE:

Pull the battery fuse box housing. DO NOT pull the flap.

Open the battery fuse box cover (1).
Remove the positive battery cable to starter nut (2).
Remove the positive battery cable to starter (3) from the battery.

Fig 3: Positive Battery Cable And Nut

GM2027592

Courtesy of GENERAL MOTORS COMPANY

Loosen the positive battery cable nut (1) on the battery.
Remove the positive battery cable (2)
Unlock the 2 retaining tabs (3) and remove positive battery cable cover.

Fig 4: Battery Hold Down

GM2027610

Courtesy of GENERAL MOTORS COMPANY

Remove the battery hold down retainer nut (2).
Remove the battery hold down retainer (1) from the battery tray (3).

Fig 5: Battery Current Sensor And Glow Plug Controller Bracket

GM2027662

Courtesy of GENERAL MOTORS COMPANY

Unclip the battery current sensor (3) from the battery tray.
Disconnect the glow plug controller wiring harness plug (4).
Remove the glow plug controller bracket (2) from the battery tray.

Fig 6: Protector Battery Tray

GM2027650

Courtesy of GENERAL MOTORS COMPANY

Unlock the retaining tab (2) and remove the protector battery tray (1).
Remove the battery with the GE-49379 remover.