Fastener Tightening Specifications
WARNING: This page is about a different car, the 2014 Chevrolet Cruze. However, it is still accessible from the selected car via links, so may be relevant.
Fastener Tightening Specifications
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Control Arm to Steering Knuckle Bolt and Nut | ||
|
50 (1) | 37 lb ft (1) |
|
120 Degrees | |
|
50 | 37 lb ft |
|
35 Degrees | |
| Control Arm to Subframe Bolt - Front | ||
|
70 (1) | 52 lb ft (1) |
|
75 - 90 Degrees | |
| Control Arm to Subframe Bolt - Rear | ||
|
70 (1) | 52 lb ft (1) |
|
75 - 90 Degrees | |
| Front Bearing to Steering Knuckle Bolt | ||
|
100 | 74 lb ft |
|
20 - 35 Degrees | |
| Front Stabilizer Shaft Insulator Clamp Bolt | ||
|
22 (1) | 16 lb ft (1) |
|
30 Degrees | |
| Front Suspension Strut Lower Bolt and Nut | ||
|
90 (1) | 66 lb ft (1) |
|
60 Degrees | |
| Front Suspension Strut Mount Nut | 65 | 48 lb ft |
| Front Suspension Support Bolt | ||
|
60 (1) | 45 lb ft (1) |
|
35 Degrees | |
| Rear Control Arm Bushing to Control Arm | ||
|
55 (1) | 41 lb ft (1) |
|
60 Degrees | |
| Stabilizer Shaft Link to Strut Nut | 65 (1) | 48 lb ft (1) |
| Steering Gear Outer Tie Rod to Steering Knuckle Nut | 35 | 26 lb ft |
| Steering Knuckle to Strut | ||
|
90 (1) | 66 lb ft(1) |
|
60-75 Degrees | |
| Strut Shaft Nut | 70 N.m | 52 lb ft |
| (1) Use NEW Fastener | ||